- The operating pressure shall not exceed the rated pressure.
- The minimum mold size shall not be less than the diameter of the piston. The mold should be placed in the middle of the hot plate; The working hydraulic pressure should be adjusted according to the size of the mold and vulcanizing time.
- Turn off the main power supply when stopping use.
- Keep the column nuts tight during operation, and check periodically whether they are loose.
- When the machine is run without mold, a 60mm thick pad must be placed in the plate.
- The main machine and control box should be reliably grounded
- Each contact must be clamped, and check regularly whether there is any loosening.
- Keep electrical components clean. Do not impact or knock the machine.
- If any fault is found, stop the machine for maintenance immediately.
Blog
The Attention Of Operation Rubber Press Machine
22
Feb
Feb
